HTM140 is similar to the RCP30 Nano Cure, however immedtiate after 3D printing and without thermal post treatment the HTM140 has a HDT of 140°C. Very sharp details can be achieved. Some applications: |
Casting tools for rubber |
Test parts in hot air and hot water environment |
Test parts for wind tunnels |
Various applications in the electronics industry |
Surfaces up to | 16μm |
Layer Thickness min. | 25μm |
Type | Photopolymer |
Colour | Olive green |
Classification | N.A. |
Properties | Units | Method | Value |
Density | [G / cm ³] | DIN ISO 1183-1 | |
Tensile Strength | [MPa] | DIN EN ISO 527-1 | 56 |
Elongation at Break | % | DIN EN ISO 527-1 | 3.5 |
Flexural Strength | [MPa] | DIN EN ISO 178 | 115 |
Flexural Modulus | [MPa] | DIN EN ISO 178 | 3350 |
Heat Deflection Temp. (HDT) zonder thermische behandeling | ° C | ASTM D 648 | 140 |
2012-01-23: added.
All data provided herein, which is related to consumables, was collected from specific specimens and tests conditions and is provided for information only. Characteristics may vary if different specimens and test conditions are applied. Unless expressly provided in writing, no warranties are made and warranties of merchantability or fitness for a particular purpose are expressly disclaimed. All data provided is preliminary and must be verified by the individual user.
Dear Customer,
We are pleased that you have an interest in our company. We are here to inform you in detail about the possibilities with prototyping and direct manufacturing.
Please contact us by phone 077 321 01 20 or by e-mail info@mareco.nl.
Kindly regards,
Mareco Prototyping B.V.